Available in Clear and 33 Standard Colours.
Suitable as a sealer for application by broom, roller or airless spray for application to concrete, pebble and slate floors.
5 – 7 Square metres per litre depending on profile and porosity of surface. First coat should be diluted with up to 20% solvent.
Application Temperature min. 5 deg C
Recoat Time Min. 4 – 6 Hrs
Full Film Formation (Cure) 7 Days.
Packaging and Safety
AUSEAL EC25 is available in 4, 10, 20 and 200 litre drums.
Refer to the Safety Data Sheet before handling or use.
All surfaces to be sealed or coated must be free from dust, dirt, oil, grease and other contaminants.
Clean all surfaces with degreasant and flush with copious quantities of clean water, scrubbing to remove all contaminants while washing down the area. Repeat this application until all residues of contaminant are removed.
Acid etch bare concrete if surface is not profiled, using hydrochloric acid diluted with 10 parts water to 1 part acid. Broom on to surface and leave to react for approximately 10 minutes. Do not allow to dry out, hosing off with copious quantities of fresh water.
Allow surface to thoroughly dry prior to sealer application.
Stir thoroughly before and during application to ensure uniformity, making sure that any suspended pigment (if coloured) is completely re-incorporated.
The First coat must be thinned with 10-20% Xylene to assist penetration and adhesion.
Apply coating evenly with broom, roller or spray gun. Uneven application may result in blistering.
Allow recommended drying time and apply evenly one full second coat without dilution.
AUSEAL EC25 can be removed from tools and equipment with Xylene.