POWERSEAL
POWERSEAL is a revolutionary product, which as proven displays superior characteristics as a concrete top coat and sealant in one. It is suitable for dry concrete based flooring of warehouses, indoor factories, service stations and garages where a very tough and hard wearing finish or coating is required. POWERSEAL is one of the toughest if not the toughest available coating in the market.
FEATURES
- Excellent durability
- Excellent resistance to fats and oils and even brake fluids
- Excellent resistance to diluted acids, alkalis and oxidising agents
- Excellent petrol and / or solvent resistance
- Excellent abrasion resistance
- Superior adhesion properties
- Suitable for interior application or under canopy applications
- Easy to clean and maintain appearance
- Very hard yet flexible coating
- Despite the coating process a high gloss appearance, it is not unusually slippery
COLOUR RANGE:
Available in Clear and 24 Standard Colours and custom colours if required.
APPLICATION:
For best results as a sealer and coating for application, use broom or roller for application to concrete.
COVERAGE:
5 – 7 Square metres per litre depending on profile and porosity of surface.
SPECIFICATION:
Application Temperature Min. 5 deg C Max.30 deg C Recoat Time Min. 4-6 Hrs and within the next 18 hours. Full Film Formation (Cure) 3 Days. Trafficable
PACKAGING AND SAFETY:
POWERSEAL is available in 4, 10, 20 and 200 litre drums. Refer to the Material Safety Data Sheet before handling or use.
DIRECTIONS FOR SURFACE PREPARATION AND APPLICATION
SURFACE PREPARATION
All surfaces to be sealed or coated must be free from dust, dirt, oil, grease and other contaminants. Clean all surfaces with degreasant and flush with copious quantities of clean water, scrubbing to remove all contaminants while washing down the area. Repeat this application until all residues of contaminant are removed. Acid etch bare concrete if surface is not profiled, using hydrochloric acid diluted with 10 parts water to 1 part acid. Broom on to surface and leave to react for approximately 10 minutes. Do not allow to dry out, hosing off with copious quantities of fresh water. Allow surface to thoroughly dry prior to sealer application.
APPLICATION
Stir thoroughly before and during application to ensure uniformity, making sure that any suspended pigment (if coloured) is completely re-incorporated. The First coat must be Powerseal tinted or untinted primer to assist penetration and adhesion. Apply coating evenly with broom or roller. Uneven application may result in slowing down of curing time. Allow recommended drying time and apply evenly one full Second coat without dilution.
CLEANING
POWERSEAL can be removed from tools and equipment with Xylene
PRECAUTIONS
- AUSEAL 1 IS A COMBUSTIBLE LIQUID.
- Provide adequate ventilation during application and drying.
- Store away from naked flames and sparks.
- Ensure you are familiar with MSDS prior to usage.
- As the product dries with the reaction with the moisture of the atmosphere, keep containers tightly closed at all times and pour a small amount of Xylene on top of every drum when opened.
- Recoating time should be strictly followed otherwise intercoat adhesion may cause a problem.
25 – 29 Pelson Court, (P.O. Box 441) Dandenong 3175. Tel: (03) 8787 8388 Fax: (03) 8787 8366 Email: auseal1@optusnet.com.au